What it is
A bathroom vanity installed out of level.
Why it matters
Water on the benchtop runs to one end and over the edge instead of staying put.
How we check it
We put a level on every vanity and benchtop.
The fix
Re-set the vanity level.
How common it is
Our digital level read 9mm per 1000mm on this new vanity.
What this means for your home
A vanity, benchtop or cabinet installed out of level is an obvious finish defect, and it also means water will not drain where it should — a basin that pools to one side, a benchtop that sheds toward the wall. The QBCC Standards and Tolerances Guide sets the acceptable variation for installed cabinetry. At handover the cabinetmaker or plumber is still on the job and re-levelling is a packing-and-refix exercise. Lived with, the tilt is a daily irritation and, where water is involved, a slow damage problem at the low corner. It usually comes from a rushed install on an uneven floor. We put a level across every vanity, benchtop and run of cabinetry, check the fall of basins and splashbacks, and photograph anything out of level so it is corrected before the trades leave site. The report shows the level reading across the cabinetry so the builder re-levels it rather than calling it close enough. Out-of-level fittings are both a daily annoyance and, where a basin or benchtop sheds water the wrong way, a slow damage problem at the low corner. It is a quick packing fix while the cabinetmaker is still on site, and an easy one to overlook without a level in hand. We check the kickboards, drawer and door alignment and the fall of the splashback at the same time, because a cabinet set out of level usually shows up in all of them, and all of them are quick to correct while the installer is still on site.